Whiteside CNC Spoilboard Surfacing Router Bit - 1/2" Shank by W…
Rating: 289 reviews from 1 sources
Reviews
Selected Review of 17 Reviews
I used this on my first slab flattening. Chucked it up on the Bosch 1617, and this thing, in some places took down 3/16 a 1/4 on the first pass. … Read full review
bitsbits.com
Selected Review of 17 Reviews
Used to flatten end grain cutting board Work perfectly. … Read full review
bitsbits.com
Selected Review of 17 Reviews
Used only once on some mesquite and performed perfectly - better than anticipated. … Read full review
bitsbits.com
Selected Review of 17 Reviews
This bit is worth its price. I have used cheaper bits in the past and they work good for the first or second use and then go downhill after … Read full review
bitsbits.com
Selected Review of 17 Reviews
Bit was much smoother than the one i was using. i was flattening end grain so there was still some tear out expected, but a lot less sanding to … Read full review
bitsbits.com
Selected Review of 17 Reviews
This tool cuts great! Control of speed and feed rate yielded the result hoped for. Worth a look for your special, but labor intensive … Read full review
bitsbits.com
Selected Review of 17 Reviews
The bit is extremely sharp and well balanced. It worked wonderfully. My one complaint would be the lack of a box. Such a sharp tool … Read full review
bitsbits.com
Selected Review of 17 Reviews
Used this bit to surface slab for a friend. As always products from Bits & Bits are top notch. … Read full review
bitsbits.com
Selected Review of 17 Reviews
I use it to flatten cutting boards and chess boards after glue Ups because my planer is 30 years old and leaves a lot of snipe. Because the bit … Read full review
bitsbits.com
Selected Review of 17 Reviews
It's a beast :-). I just used it to flatten my CNC spoilboard then a cutting board I'm making. Not only were the results good, but with it's size it … Read full review
bitsbits.com
Selected Review of 17 Reviews
Absolutely great. Does a great job at sufacing wood slabs. I did two 37X40 cedar slabs (crosscut endgrain) and it performed very nicely. … Read full review
bitsbits.com
Selected Review of 17 Reviews
This bit chewed through anything I could toss at it-just recently used to cut the depth for a c-channel inlay on a dining table and worked like a … Read full review
bitsbits.com
Selected Review of 17 Reviews
This is my second Whiteside bit, I also have the 1/2" x 1" cut as well - very good quality even on end grain. … Read full review
bitsbits.com